Actel flashpro3 programmer driver

8 rows · ACTEL FLASHPRO3 PROGRAMMER DRIVER DETAILS: Or ethernet port to the pinedit. The high-performance. 4 2 – Installing FlashPro Software FlashPro software supports all FlashPro programmers, i.e. FlashPro5, FlashPro4, FlashPro3x, FlashPro3, FlashPro Lite, FlashPro and the Low Cost Programming Stick (LCPS). The new FlashPro3 dedicated driver provides a whole host of usability benefits compared to the previously used HID driver. However, as it is a completely new driver, older versions of the software will no longer work once the new version is installed.

• FlashPro Actel Programmer • IEEE 25 pin cable, Type A-C, 10 ft. • Loop Back Test board • Power supply brick and cable • USB A to B Cable FlashPro Lite Kit The FlashPro Lite kit contains: • FlashPro CD • FlashPro Lite Programmer • IEEE 25 pin extension cable, Type A-A, 10 ft. • 18 inch programmer target cable, The new FlashPro3 dedicated driver, introduced with FlashPro v, provides a whole host of usability benefits compared to the previously used HID driver. However, as it is a completely new driver, older versions of the software will no longer work once the new version is installed. Software releases: www.doorway.ru Hardware Installation After installing the software successfully, connect one end of the USB cable to the FlashPro3 device programmer and the other end to your PC USB port. The Found Hardware Wizard will open twice. Use the wizard to install the driver automatically (recommended).

For a standalone FlashPro default installation, the drivers are located at C:/Actel/FlashPro/Drivers/Manual. Actel recommends the automatic driver installation. FlashPro3 is not supported on Windows • PC support: Libero supports programming of all families. For SmartFusion, Fusion, IGLOO, and. Evaluation Board with an AFSFG Fusion Device. — Actel Libero® Integrated Design Environment (IDE) Gold. — FlashPro3 and Programming Cable.